Rpp Timing Belts

The RPP belt with the new parabolic profile has teeth thicker than in standard belts of comparable pitch, this characteristics and the " bulkiness" of the teeth allow both an appreciable increase in power transmission as well as a reduction in interference between belt and pulley during mesh. The indentation at the top of the tooth during mesh. This permits easier air discharge & reduced noise levels. The new parabolic tooth profile and the reduced interference during mesh allow :
* Greater resistance to tooth jump
* Improved power capability
* Improved shear stress resistance
* Use of standard HTD or RPP pulleys
* Pitches available are : RPP3, RPP5, RPP8 and RPP14

These belts are particularly recommended for high torque drives where :
* An increase of upto 100% in belt load can be achieved using    the same
  sized pulleys as for RPP belts. Alternately, a    consequent reduction in
   pulley width can be obtained.
* The same pulleys used for HTD or RPP system can be used
   maintaining functional interchangeability
* The life of existing systems can be improved without changing the pulleys.
* Pitches available are : RPP PLUS8 and RPP PLUS14